ATM Services Configuration Guide for CBX 3500, CBX 500, GX 550, and B-STDX 9000 21-1
Beta Draft Confidential
21
Configuring PNNI Routing
This chapter describes how to configure the ATM Private Network-to-Network
Interface (PNNI) routing protocol and routing hierarchies in your Lucent network.
The PNNI is a standard designed by the ATM Forum. This standard defines both an
ATM routing protocol and an ATM signaling protocol. Lucent supports PNNI on the
CBX 3500, CBX 500, and GX 550 Multiservice switch platforms.
For a detailed explanation of PNNI routing and signaling, see the ATM Forum
Technical Committee Private Network-Network Interface Specification Version 1.0
(af-pnni-0055.000), available from the ATM Forum’s Web site:
http://www.atmforum.com.
This chapter describes the following topics and tasks:
• “Supported PNNI Features” on page 21-2
• “PNNI Routing Protocol Overview” on page 21-8
• “PNNI Signaling Overview” on page 21-14
• “Integrating VNN OSPF and PNNI Networks” on page 21-17
• “Frame Relay-to-ATM Over PNNI Interworking” on page 21-19
• “PNNI Reroute Load Balancing” on page 21-20
• “Resilient UNI and APS Resilient UNI Over PNNI” on page 21-25
• “PNNI Policy-based Routing” on page 21-27
• “Configuring PNNI Routing” on page 21-41
• “Configuring SPVCs (Offnet Circuits) Over PNNI” on page 21-55
• “PNNI Trap Support” on page 21-56
To Next Page
Loading...
Need help?
General
