Lucent Technologies CBX 3500 - Page 9

Contents
ATM Services Configuration Guide for CBX 3500, CBX 500, GX 550, and B-STDX 9000 ix
Beta Draft Confidential
Chapter 3 Configuring CBX or GX Logical Ports
Working With ATM Logical Ports............................................................................3-2
Accessing LPorts in the Switch Tab....................................................................3-2
Adding an ATM Logical Port .............................................................................3-4
Defining a Logical Port.......................................................................................3-9
Modifying an ATM Logical Port ......................................................................3-10
Setting Logical Port Attributes ................................................................................3-14
General Attributes .............................................................................................3-16
Administrative Attributes..................................................................................3-20
Configuring VP Shaping on CBX 500 Virtual UNI Logical Ports...................3-25
Before You Begin.......................................................................................3-25
Virtual ATM UNI Logical Port Configuration Considerations..................3-25
Modifying the VP Shaping Mode on GX 550 Virtual UNI Logical Ports........3-27
ATM Attributes.................................................................................................3-27
ILMI/OAM Attributes.......................................................................................3-34
CES Attributes...................................................................................................3-37
Traffic Descriptor Attributes.............................................................................3-41
OPTimum Trunk VPI Range Attributes............................................................3-45
ATM FCP Attributes.........................................................................................3-49
Tunnel VP Shaping Rate Attributes..................................................................3-50
QoS Attributes .........................................................................................................3-51
Setting QoS Parameters.....................................................................................3-51
Setting SVC QoS Parameters............................................................................3-56
Completing the Logical Port Configuration ............................................................3-57
Configuring Virtual ATM UNI/NNI Logical Ports.................................................3-58
Configuring Logical Ports for Use With ATM SVCs .............................................3-59
Chapter 4 Configuring ATM Logical Ports on Frame-based Modules
About ATM Logical Ports.........................................................................................4-2
ATM UNI DCE...................................................................................................4-2
ATM UNI DTE ...................................................................................................4-2
ATM Direct Trunk/Direct Cell Trunk.................................................................4-2
ATM OPTimum Cell Trunk................................................................................4-3
ATM OPTimum Frame Trunk............................................................................4-4
Network Interworking for Frame Relay NNI......................................................4-4
Setting the Number of Valid Bits in VPI/VCI for the B-STDX 9000.......................4-5
Using VP Shaping......................................................................................................4-6
I/O Modules for ATM Services.................................................................................4-7
Configuring Ports for ATM DXI/FUNI and ATM Services .....................................4-8
IOMs for ATM Interworking Services................................................................4-8
Logical Port Congestion Thresholds..........................................................................4-9
About ATM Logical Port Functions........................................................................4-11
About the ATM Logical Port Attributes ...........................................................4-11
Adding an ATM Logical Port..................................................................................4-14