Index-6 Manual # 42-02-7223
Current Control 9-113
Dampening Current 9-113
Current Limit LED 4-8, 4-10
Current Loop Integral, System 12 drive 2-51
Current Sensor, System 12 drive 2-51
Custom Outputs 9-147
Custom outputs, configuring 9-165
D
DAC Offset Status test point, description 11-4
DAC, verifying DAC conversion 2-49
Dampening parameters 9-112
Data trap 9-12
Data Trap Triggering Event 9-12
DBD Anti-nuisance 9-96
DBD COP Panel Activation 9-96
DBD Door dwell timers 9-96
DBD Lobby Settings 9-96
DBD Mode Activated message 6-23
DBD PHE Antinuisance 6-23
DCAB, Door Contact Access Bottom input 6-112, 11-11
DCAT, Door Contact Access Top input 6-112, 11-11
DCL, Door Close Limit input 6-110, 11-8
DCMS, Door Contact Main String input 6-112, 11-11
Dead zone distance parameter 9-156
Dead zone, adjusting for final stop 4-32
Deceleration parameter 4-18, 9-158
Deceleration rate, bunching up of 4-20
Default IP Addresses 2-34
iBox settings 7-9
default parameter settings, saving 8-20
Delayed Mechanically In Service output 9-138
Demand Down Peak 10-83
Demand Down Peak Mode message 6-23
Demand Down Peak mode, selecting 10-16
demand peak detection parameters 10-18
Demand peak options 10-18
Demand peak parameters 10-20
Demand Up Peak 10-83
Demand Up Peak Mode message 6-23
Demand Up Peak mode, selecting 10-16
Destination Based Dispatching (DBD) ??–9-98, 10-34–10-38
Car Fixtures 9-98
Description 10-34
Destination Input Device (DID) 10-36
Enable-Disable 9-96
Fixtures 9-97
Floor settings 9-96
Hall Fixtures 9-98
Hallway configuration 10-37
Timers 10-36
DETS, Down Emergency Terminal Limit switch 6-111, 11-9
Devices configuration 9-35–9-40
Diagnostic Flags 9-13
Diagnostic flags
Car Operation 9-13
Drive 9-13
Motion 9-13
Safety 9-13
Diagnostic Outputs window 9-14
Diagnostics 9-10–9-24
Call Generator 9-11
Car Statistics tab 9-10
Data Trap 9-12
Diagnostic Flags 9-13
Event Log 9-15
Event Log Filter 9-17
Event Properties 9-16
Fault Bypass 9-18
System Event Log Filter 10-79
Terminal Switches Status 9-20
Virtual Oscilloscope 9-22
Diagnostics - Call Generator 9-11
Differential low-pass frequency parameter 9-109
Digital PI Outputs I and II 9-40
Direct connections 8-8–8-11
3 = PC port 2-35
connecting 8-10
creating 2-39, 8-8
Direction arrow down 2 output 9-138
Direction Arrow Down output 9-138
Direction arrow up 2 output 9-138
Direction Arrow Up output 9-138
Disable car sounds, silent mode 9-37
Disable Front Hall Door Buttons input 9-132
Disable Rear Hall Door Buttons input 9-132
Discontinuous Current
Integral 9-107
Proportional 9-107
Discrete PI Outputs tab 9-40
Dispatcher = Car ‘n’ message 6-23
Dispatching
Configuration, Simplex / Swing / Backup Dispatch 10-13
Dispatching substitution lag time 10-8
Dispatching tab 10-11
Display contrast, iBox control 7-4
DLAB, Door Lock Access Bottom input 6-112, 11-11
DLAT, Door Lock Access Top input 6-112, 11-11
DLM, Down Leveling Marker Sensor input 6-110, 11-8
DLMS, Door Lock Main String input 6-112, 11-11
DN ETS POSITION FAULT message 6-24
DN NTSn L1 SPEED FLT message 6-25
DN NTSn L2 SPEED FLT message 6-25
DN NTSn POSITION FLT message 6-26
DNT1, Down Slowdown Limit switch #1 input 6-111, 11-9
DNT2, Down Slowdown Limit switch #2 input 6-111, 11-9
DNT3, Down Slowdown Limit switch #3 input 6-111, 11-9
DNT4, Down Slowdown Limit switch #4 input 6-111, 11-9
DNT5, Down Slowdown Limit switch #5 input 6-111, 11-9
DNTD, Down Normal Limit Direction switch input 6-111, 11-9
docking and undocking windows in iView 8-35
DOL, Door Open Limit input 6-110, 11-8
Door close delay timer 9-31
Door Close Protection Timer 9-32
Door Dwell Timers 9-45
ADA Call 9-45
Car Call 9-45
Hall Call 9-45
Lobby Call Dwell 9-45
Reopen Dwell 9-45
To Next Page
Loading...