Rohde & Schwarz R&S ZNA Series - Page 1458

Command reference
R&S
®
ZNA
1458User Manual 1178.6462.02 ─ 29
[SENSe<Ch>:]PATH<Pt>:MEASurement:IFRequency?....................................................1462
[SENSe<Ch>:]PATH<Pt>:REFerence:IFRequency?.........................................................1462
[SENSe<Ch>:]PATH<Pt>:MEASurement:IFSWitch?........................................................ 1462
[SENSe<Ch>:]PATH<Pt>:REFerence:IFSWitch?.............................................................1462
[SENSe<Ch>:]PATH<Pt>:DIRectaccess <path>
Defines the direct generator/receiver access path.
Same functionality as SOURce<Ch>:PATH<Pt>:DIRectaccess
Note that direct generator/receiver access and direct IF input cannot be used at the
same time. Direct generator/receiver access is only used if [SENSe<Ch>:
]PATH<Pt>:IFSWitch is set to OFF or OUT.
Suffix:
<Ch>
.
Channel number
<Pt> Port number
Setting parameters:
<path> NONE | B16 | REV | SRC
NONE
Direct generator/receiver access not used (Out/In pairs jum-
pered)
B16
Standard use of direct generator/receiver access
REV
Reverse coupler configuration
SRC
Source monitor access
Usage: Setting only
Options: R&S ZNAxx-B16
Manual operation: See "Receiver Input" on page 678
[SENSe<Ch>:]PATH<Pt>:IFINpath <Direct IF Access InPath>
Selects the input paths of the Direct IF Access Input / Output connectors IF Reference
<Pt> and IF Meas <Pt> in channel <Ch>.
This setting only takes effect if [SENSe<Ch>:]PATH<Pt>:IFSWitch is set to IN.
Suffix:
<Ch>
.
Channel number
<Pt> Port number
Setting parameters:
<Direct IF Access
InPath>
DIRect | LP_60m | BP_279m
DIRect
Frequency range 5kHz to 1 GHz
SCPI command reference