Rohde & Schwarz R&S ZNA Series - Page 1837

Index
R&S
®
ZNA
1837User Manual 1178.6462.02 ─ 29
Channels tab
Active Channel ..........................................................653
Channel Manager... .................................................. 655
Channel On ...............................................................655
Controls .................................................................... 653
Copy Channel ........................................................... 654
Copy Channel + Diagram ......................................... 654
Delete Channel ......................................................... 655
Fixture Simulator ....................................................... 655
New Channel ............................................................ 654
New Channel + Diagram ...........................................654
Characterization
Cal Unit ..................................................................... 587
Characterization Data ..................................................... 622
Characterization wizard ...................................................623
Test Port Assignment ................................................ 625
Characterize Cal Unit dialog ........................................... 621
Authentication ........................................................... 622
Set Password ............................................................622
Checking the delivery ........................................................ 82
Chirp z-transformation .....................................................248
Circle limit ........................................................................172
Circle Test ....................................................................... 492
Clear Test ..................................................................495
Define circle .............................................................. 495
Draw Circle ............................................................... 495
Limit Check ............................................................... 493
Limit Fail Beep .......................................................... 495
Show Limit Circle ...................................................... 492
Circular diagrams .............................................................. 69
Color Scheme ................................................................. 845
Colorize Trace when Failed .............................................849
Command
common .................................................................... 939
device-specific .......................................................... 939
Processing ................................................................ 949
Recognition ............................................................... 949
Sequence ..................................................................949
structure and syntax ................................................. 939
Synchronization ........................................................ 949
Command reference ....................................................... 971
Common commands ............................................... 968, 970
Common mode ........................................................161, 163
Common Mode ................................................................356
Compatibility mode
Sweep Active Channel .............................................. 569
Sweep All Channels .................................................. 569
Compression measurements .......................................... 391
Computer name
Changing ................................................................ 1777
CONDition ............................................................... 955, 956
Configured devices
external generators ........................................... 898, 923
external power meters .............................................. 893
External switch matrices ........................................... 911
Connector panel
Diplexer .......................................................................91
Connectors .................................................................... 1779
Context menu .................................................................. 135
Continuous data recording
Controlled Timing ...................................................... 566
Continuous sweep ...........................................................565
Control bus .................................................................... 1782
Control elements ............................................................... 48
Control lines (GPIB bus) ............................................... 1782
Controlled Timing ............................................................ 566
Converter setup ...............................................................100
Couple Active Trace ........................................................ 429
Couple All Traces ............................................................ 429
Customer support ..........................................................1770
CW Frequency ................................................................ 524
CW Mode Spectrum ........................................................ 381
CW Mode sweep ............................................................. 549
D
Data & Func to <Destination> ......................................... 438
Data base ........................................................................ 949
Data bus (GPIB) ............................................................ 1782
Data entry ..........................................................................62
Data Entry panel ............................................................... 38
Data flow ......................................................................... 120
Data sheets ....................................................................... 22
Data Streaming ................................................................. 41
Data to <Destination> ..................................................... 438
Data Valid ...................................................................... 1782
DAV ............................................................................... 1782
dB Mag ............................................................................ 420
DC bias
Force ...........................................................................91
GND ............................................................................ 91
Sense ..........................................................................91
DC power .......................................................................... 99
DC Value ......................................................................... 452
DCL ..................................................................... 1781, 1783
DCL, SDC ....................................................................... 967
Decouple Active Trace .................................................... 429
Decouple All Traces ........................................................ 429
Deembedding
Balanced ........................................................... 712, 713
Ground Loop ..................................................... 713, 714
Impedance Renormalization ............................. 714, 715
Port Sets ........................................................... 710, 711
Single Ended ............................................................ 709
DEFault ........................................................................... 943
Default file locations ...................................................... 1271
Define Calibration
Dialog ........................................................................585
Define Limit Lines dialog ................................................. 482
Define Parallel Measurement dialog ............................... 682
Balanced Ports tab ................................................... 684
DUT Definition tab .................................................... 684
Frequency Offset tab ................................................ 685
Minimum Offset ......................................................... 685
Modify an existing DUT ............................................. 684
Parallel Measurement with Frequency Offset ........... 685
Reference Impedance tab ........................................ 684
State indication popup .............................................. 686
Define Physical Ports dialog ........................................... 919
Define Ripple Test dialog ................................................ 490
Define Segments dialog .................................................. 553
Displayed Columns ................................................... 556
Define User Color Scheme dialog ................................... 847
Delay ............................................................................... 167
Delay (Offset Embed) ..............................................717, 718
Delete All Cal Kits ........................................................... 860
Delete All Mem ................................................................ 441
Delete Cal Pool ............................................................... 860
Delete Trace .................................................................... 433
Delta Mode ...................................................................... 500
Delta-L 4.0 PCB characterization .................................... 300
Denominator ....................................................................364
Destination (memory trace) ............................................. 439
Destination (memory traces) ........................................... 440