EasyManuals Logo

AudioCodes Mediant MSBR Series User Manual

AudioCodes Mediant MSBR Series
801 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #367 background imageLoading...
Page #367 background image
Version 7.2 367 Mediant MSBR
Reference Guide 59. gateway
Command Description
cisco-sce-mode
In use with G.729 - if enabled and SCE=2 then
AnnexB=no.
clir-reason-support
Enables sending of Reason for Non Notification of Caller
Id.
connect-on-progress-
ind
FXS: generate Caller Id signals during ringing FXO:
collect
CallerId and use it in Setup message.
copy-dst-on-empty-src
In case there is an empty source number from PSTN the
source number will be the same as the destination.
cp-dst-nb-2-redir-nb
Copy Destination Number to Redirect Number.
cpc-mode
Calling Party Category Mode.
cut-through-enable
Enable call connection without On-Hook/Off-Hook process
'Cut-Through'.
cut-thru-reord-dur
Duration of reorder tone played after release from IP side
for CutThrogh application
dflt-call-prio
SIP Default Call Priority.
dflt-cse-map-isdn2sip
Common cause value to use for most ISDN release
causes.
dig-oos-behavior
Digital OOS Behavior.
disc-call-pi8-alt-rte
If set to 1 and ISDN DISCONNECT with PI is received,
183 with SDP will be sent toward IP only if no IP-to-Tel
alternative route exists.
disc-on-bsy-tone-c
Disconnect Call on Busy Tone Detection – CAS.
disc-on-bsy-tone-I
Disconnect Call on Busy Tone Detection – ISDN.
dscp-4-mlpp-flsh
RTP DSCP for MLPP Flash.
dscp-4-mlpp-flsh-ov
RTP DSCP for MLPP Flash Override.
dscp-4-mlpp-flsh-ov-ov
RTP DSCP for MLPP Flash-Override-Override.
dscp-4-mlpp-immed
RTP DSCP for MLPP Immediate.
dscp-for-mlpp-prio
RTP DSCP for MLPP Priority.
dscp-for-mlpp-rtn
RTP DSCP for MLPP Routine.
dst-number-plan
Enforce this Q.931 Destination Number Type.
dst-number-type
Enforce this Q.931 Destination Number Type.
dtmf-used
Send DTMFs on the Signaling path (not on the Media
path).
e911-mlpp-bhvr
Defines the MLPP E911 Preemption mode.
early-amd
If set to 1, AMD detection is started on PSTN alerting
otherwise on connect.
early-answer-timeout
Max time (in seconds) to wait from sending Setup
message to PSTN to receiving Connect message from
PSTN.
energy-detector-cmd
-

Table of Contents

Other manuals for AudioCodes Mediant MSBR Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the AudioCodes Mediant MSBR Series and is the answer not in the manual?

AudioCodes Mediant MSBR Series Specifications

General IconGeneral
BrandAudioCodes
ModelMediant MSBR Series
CategoryNetwork Router
LanguageEnglish

Related product manuals