Version 7.2 719 Mediant MSBR
Reference Guide 75. Layer-3 Commands
Command Mode
Privileged User
Example
This example sets the RIP enable interface by network.
(conf-router)# network network 10.4.4.10/16
75.2.2.81.2.2 network ifname
This command sets a RIP enabled interface by ifname. Both the sending and receiving of
RIP packets will be enabled on the port specified in the network ifname command.
The no network ifname command disables RIP on the specified interface.
Syntax
network ifname
no network ifname
Interface Type (ifname) Interface ID
gigabitethernet
GigabitEthernet interface slot
and port (VLAN ID is optional)
[SLOT/PORT.VLANID]
cellular Cellular interface ID 0/0
gre Tunnel GRE ID [1-255]
ipip Tunnel IPIP ID [1-255]
l2tp L2TP ID [0-99]
pppoe PPPoE interface ID [1-3]
pptp PPTP ID [0-99]
vlan Vlan ID [1-3999]
loopback Loopback ID [1-5]
bvi Bridge interface [1-255]
Default
NA
Command Mode
Privileged User
Example
This example sets the RIP enable interface by ifname.
(conf-router)# network vlan 1
To Next Page
Loading...
