Reference Guide 720 Document #: LTRT-17939
Mediant MSBR
75.2.2.81.2.3 neighbor a.b.c.d
This command is used to specify neighbors when a neighbor can’t process multicast. In some
cases, not all routers are able to understand multicasting, where packets are sent to a
network or a group of addresses. In a situation where a neighbor cannot process multicast
packets, it is necessary to establish a direct link between routers. The neighbor command
allows the network administrator to specify a router as a RIP neighbor.
The no neighbor a.b.c.d command will disable the RIP neighbor.
Syntax
neighbor a.b.c.d
no neighbor a.b.c.d
Command Description
a.b.c.d Defines the neighbor address.
Default
NA
Command Mode
Privileged User
Example
This example specifies a neighbor.
(conf-router)# neighbor 10.4.4.4
75.2.2.81.2.4 version version
This command sets the RIP version number.
Syntax
version version
no version
Command Description
version Defines the RIP version number – “1” or “2”
Default
“2” for send
Both “1” and “2” for receive
Command Mode
Privileged User
To Next Page
Loading...
