3-6
Cisco ONS 15454 SDH Procedure Guide, R7.0
78-17194-01
Chapter 3 Connect the PC and Log into the GUI
NTP- D262 Set Up a Remote Access Connection to the ONS 15454 SDH
NTP-D262 Set Up a Remote Access Connection to the
ONS
15454 SDH
Step 1 Connect the modem to the RJ-45 (LAN) port on the TCC2/TCC2P card or the RJ-45 jack on the
MIC-C/T/P FMEC.
Step 2 While referring to the modem documentation, complete the following tasks to provision the modem for
the ONS 15454 SDH:
• For CTC access, set the modem for Ethernet access.
• Assign an IP address to the modem that is on the same subnet as the ONS 15454 SDH.
• The IP address the modem assigns to the CTC computer must be on the same subnet as the modem
and the ONS 15454 SDH.
Step 3 Continue with the “NTP-D23 Log into the ONS 15454 SDH GUI” procedure on page 3-7.
Stop. You have completed this procedure.
Purpose This procedure connects the CTC computer to an ONS 15454 SDH using a
LAN modem.
Tools/Equipment Modem and modem documentation. The modem must be:
• Connected to the ONS 15454 SDH
• Provisioned for the ONS 15454 SDH
• Provisioned for Ethernet access to run CTC
Prerequisite Procedures NTP-D278 Set Up Computer for CTC, page 3-2
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level None
To Next Page
Loading...
