18-74
Cisco ONS 15454 SDH Procedure Guide, R7.0
78-17194-01
Chapter 18 DLPs D100 to D199
DLP- D187 Provision a Low-Order VC11 Circuit Route
Step 4 From the VC4 drop-down list, choose the source VC4.
Step 5 From the TUG3 drop-down list, choose the source TUG3.
Step 6 From the TUG2 drop-down list, choose the source TUG2.
Step 7 From the VC11 drop-down list, choose the source VC11.
Step 8 If you need to create a secondary source, for example, a subnetwork connection protection (SNCP) ring
bridge/selector circuit entry point in a multivendor SNCP ring, click Use Secondary Source and repeat
Steps 1 through 7 to define the secondary source. If you do not need to create a secondary source,
continue with Step 9.
Step 9 Click Next.
Step 10 From the Node drop-down list, choose the destination (termination) node.
Step 11 From the Slot drop-down list, choose the slot containing the destination card. You can choose a MRC-12
or STM-N card to map the VC11 to a VC4 for optical transport.
Step 12 Depending on the destination card, choose the destination port from the drop-down lists that appear
based on the card selected in Step 11. See Table 6-2 on page 6-3 for a list of valid options. CTC does
not show ports, VC4s, TUG3s, TUG2s, or VC11s already used by other circuits.
Note If you and a user working on the same network choose the same VC4, TUG3, TUG2, or VC11
simultaneously, one of you receives a Path in Use error and is unable to complete the circuit. The
user with the incomplete circuit needs to choose new destination parameters.
Step 13 If you need to create a secondary destination, for example, an SNCP ring bridge/selector circuit exit
point in a multivendor SNCP ring, click Use Secondary Destination and repeat Steps 10 through 12 to
define the secondary destination.
Step 14 Click Next.
Step 15 Return to your originating procedure (NTP).
DLP-D187 Provision a Low-Order VC11 Circuit Route
Step 1 In the Circuit Creation wizard in the Route Review and Edit area, click the source node icon if it is not
already selected.
Purpose This task provisions the circuit route for low-order VC11 manually routed
circuits.
Tools/Equipment None
Prerequisite Procedures DLP-D60 Log into CTC, page 17-49
NTP-D335 Create a Manually Routed Low-Order VC11 Circuit, page 6-12
You must have the Route Review and Edit page of the Circuit Creation
wizard open.
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Provisioning or higher
To Next Page
Loading...
