Cisco ONS 15454 SDH - Figure 21-3 Store Profile(S) Dialog Box

21-8
Cisco ONS 15454 SDH Procedure Guide, R7.0
78-17194-01
Chapter 21 DLPs D400 to D499
DLP- D425 Create a New or Cloned Alarm Severity Profile
node that contains the card. (If you are creating profiles, you can apply these separately at the network
level or at the card level. To do this, refer to the “DLP-D117 Apply Alarm Profiles to Cards and Nodes”
task on page 18-18.)
Step 10 Modify (customize) the new alarm profile:
a. In the new alarm profile column, double-click the alarm severity you want to change in the custom
profile.
b. Choose a severity from the drop-down list.
c. Repeat Steps 10a and 10b for each severity you want to customize. Refer to the following guidelines
when you view the alarms or conditions after making modifications:
• All CR or MJ default or user-defined severity settings are demoted to MN in NSA situations.
• Default severities are used for all alarms and conditions until you create and apply a new profile.
• Changing a severity to inherited (I) or unset (U) does not change the severity of the alarm.
Step 11 After you have customized the new alarm profile, right-click the profile column to highlight it.
Step 12 Click Store.
Step 13 If you want to save the profile to a node:
a. In the Store Profile(s) dialog box, click To Node( s) (Figure 21-3).
Figure 21-3 Store Profile(s) Dialog Box
b.
If you want to save the profile to only one node, click the node in the Node Names list.
c. If you want to save the profile to all nodes, click Select All.
d. If you do not want to save the profile to any nodes, click Select None.
e. If you want to update alarm profile information, click (Synchronize).
Step 14 If you want to save the profile to a file:
a. In the Store Profile(s) dialog box (Figure 21-3), click To File .
b. Click Browse and navigate to the profile save location.
c. Enter a name in the File name field.