20-28
Cisco ONS 15454 SDH Procedure Guide, R7.0
78-17194-01
Chapter 20 DLPs D300 to D399
DLP- D335 Install GBIC or SFP/XFP Devices
DLP-D335 Install GBIC or SFP/XFP Devices
Warning
Class 1 laser product.
Statement 1008
Warning
Because invisible laser radiation may be emitted from the aperture of the port when no cable is
connected, avoid exposure to laser radiation and do not stare into open apertures.
Statement 70
Note OC192SR1/STM64IO Short Reach and OC192/STM64 Any Reach cards are listed as OC192-XFP cards
in CTC.
Note The operating temperature of the DWDM GBICs is 23 degrees Fahrenheit (–5 degrees Celsius) to
104 degrees Fahrenheit (40 degrees Celsius).
Note GBICs and SFPs are hot-swappable and can be installed or removed while the card or shelf assembly is
powered and running.
Note All versions of GBICs used with the ONS 15454 SDH can be one of two types: with clips or with a
handle.
Purpose This task installs Gigabit Interface Converters (GBICs), which are required
for E-Series Ethernet, G-Series Ethernet, CE-1000-4, and FC_MR-4 cards,
and Small Form-factor Pluggables (SFPs/XFPs), which are required for
ML1000-2, 15454_MRC-12 (MRC-12), OC192SR1/STM64IO Short
Reach (STM64-XFP Short Reach), and OC192/STM64 Any Reach
(STM64-XFP Any Reach) cards. SFPs/XFPs are hot-swappable
input/output devices that plug into a line card port to link the port with the
fiber-optic network. For a description of SFP/XFP devices on transponder
(TXP) or muxponder (MXP) cards, refer to the Cisco ONS 15454 DWDM
Procedure Guide.
Tools/Equipment For the E1000-2-G, G1K-4, ML1000-2, ML100X-8, CE-1000-4, or
FC_MR-4 cards, use the SX, LX, ZX, or DWDM GBICs shown in
Table 20-8 on page 20-29.
For the ML1000-2, MRC-12, STM64-XFP Short Reach, and STM64-XFP
Any Reach cards, use the SFPs/XFPs shown in Table 20-9 on page 20-29.
Prerequisite Procedures DLP-D39 Install Ethernet Cards, page 17-30
NTP-D286 Install the FC_MR-4 Cards, page 2-12
Required/As Needed As needed
Onsite/Remote Onsite
Security Level None
To Next Page
Loading...
