19-9
Cisco ONS 15454 SDH Procedure Guide, R7.0
78-17194-01
Chapter 19 DLPs D200 to D299
DLP- D212 Create a User Data Channel Circuit
Step 5 Refresh the Ethernet statistics:
a. Click the Performance > Ether Ports > Statistics tabs.
b. Click Refresh.
Note Reprovisioning an Ethernet port on the CE-1000-4 card does not reset the Ethernet statistics for
that port.
Step 6 Return to your originating procedure (NTP).
DLP-D212 Create a User Data Channel Circuit
Step 1 In network view, click the Provisioning > Overhead Circuits tabs.
Step 2 Click Create.
Step 3 In the Overhead Circuit Creation dialog box, complete the following fields in the Circuit Attributes area:
• Name—Assign a name to the circuit. The name can be alphanumeric and up to 48 characters
(including spaces).
• Type—Choose either User Data-F1 or User Data D4-D12 from the drop-down list.
Step 4 Click Next.
Step 5 In the Circuit Source area, complete the following:
• Node—Choose the source node.
• Slot—Choose the source slot.
• Port—If displayed, choose the source port.
Step 6 Click Next.
Step 7 In the Circuit Destination area, complete the following:
• Node—Choose the destination node.
• Slot—Choose the destination slot.
• Port—If displayed, choose the destination port.
Step 8 Click Finish.
Purpose This task creates a user data channel (UDC) circuit on the
ONS 15454 SDH. A UDC circuit allows you to create a dedicated data
channel between nodes.
Tools/Equipment STM cards must be installed.
Prerequisite Procedures NTP-D24 Verify Card Installation, page 4-2
DLP-D60 Log into CTC, page 17-49
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Provisioning or higher
To Next Page
Loading...
