EasyManua.ls Logo

Cisco ONS 15454 SDH - NTP- D374 Upgrade STM-N Cards Manually

Cisco ONS 15454 SDH
860 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
12-12
Cisco ONS 15454 SDH Procedure Guide, R7.0
78-17194-01
Chapter 12 Upgrade Cards and Spans
NTP- D374 Upgrade STM-N Cards Manually
Step 4 Complete the appropriate task:
DLP-D293 Perform a Manual Span Upgrade on a Two-Fiber MS-SPRing, page 19-78
DLP-D294 Perform a Manual Span Upgrade on a Four-Fiber MS-SPRing, page 19-79
DLP-D295 Perform a Manual Span Upgrade on an SNCP, page 19-80
DLP-D296 Perform a Manual Span Upgrade on a 1+1 Protection Group, page 19-81
DLP-D297 Perform a Manual Span Upgrade on an Unprotected Span, page 19-82
Note The span upgrade process resets the line’s CV-L threshold to factory default. The CV-L threshold
is reset because the threshold is dependent on line rate.
Note Span upgrades do not upgrade SDH topologies; for example, 1+1 protection group to a two-fiber
MS-SPRing.
Note An STM-1 to eight-port STM-1 span upgrade, or an STM-4 to four-port STM-4 span upgrade
can only be performed from Slots 1 to 4 and 14 to 17 because the STM1-8 and STM4-4 card can
only be installed in these slots. Ensure that the STM-1 and STM-4 cards are in these slots before
performing a span upgrade to the STM1-8 and STM4-4. The four STM-1 ports will be
sequentially mapped to Ports 1 to 4 on the eight-port STM-1 card. The STM-4 port will be
mapped to Port 1 on the four-port STM-4 card.
Stop. You have completed this procedure.
NTP-D374 Upgrade STM-N Cards Manually
Warning
Do not reach into a vacant slot or chassis while you install or remove a module or a fan. Exposed
circuitry could constitute an energy hazard.
Statement 206
Purpose This procedure upgrades STM-N cards and is not applicable to electrical
card upgrades. STM-N card upgrades can be performed only on STM-N
drop cards. If the STM-N card is used as a trunk card or is involved in a
two-fiber or four-fiber MS-SPRing, perform a span upgrade.
Tools/Equipment
Higher-rate cards
XC-VXL-2.5G, XC-VXL-10G, or XC-VXC-10G cards
Attenuators may be required for some upgrades.
Prerequisite Procedures “DLP-D60 Log into CTC” task on page 17-49
Required/As Needed As needed
Onsite/Remote Onsite
Security Level Provisioning or higher

Table of Contents

Other manuals for Cisco ONS 15454 SDH

Related product manuals