Cisco ONS 15454 SDH - DLP- D348 View ML-Series Ether Ports PM Parameters

20-56
Cisco ONS 15454 SDH Procedure Guide, R7.0
78-17194-01
Chapter 20 DLPs D300 to D399
DLP- D348 View ML-Series Ether Ports PM Parameters
Step 5 Return to your originating procedure (NTP).
DLP-D348 View ML-Series Ether Ports PM Parameters
Note For ML-Series card provisioning, refer to the Ethernet Card Software Feature and Configuration Guide
for the Cisco ONS 15454, Cisco ONS 15454 SDH, and Cisco ONS 15327.
Step 1 In node view, double-click the ML-Series Ethernet card where you want to view PM counts. The card
view appears.
Step 2 Click the Performance > Ether Ports tabs (Figure 20-11).
Figure 20-11 Ether Ports on the Card View Performance Window
Step 3
Click Refresh. PM statistics for each port on the card appear.
Purpose This task enables you to view ML-Series Ethernet port PM counts at
selected time intervals to detect possible performance problems.
Tools/Equipment None
Prerequisite Procedures DLP-D60 Log into CTC, page 17-49
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Retrieve or higher
124920
Ether Ports
tab
Performance
tab
Card View
Auto-refreshRefresh
button
Baseline
button