20-54
Cisco ONS 15454 SDH Procedure Guide, R7.0
78-17194-01
Chapter 20 DLPs D300 to D399
DLP- D343 Change SDH Threshold Settings for STM-N Cards
DLP-D343 Change SDH Threshold Settings for STM-N Cards
Note For the default values and domains of user-provisionable card settings, refer to the “Network Element
Defaults” appendix in the Cisco ONS 15454 SDH Reference Manual.
Step 1 In node view, double-click the STM-N card where you want to change the SDH threshold settings.
Step 2 Click the Provisioning > SDH Thresholds tabs.
Note If you want to modify a threshold setting, it might be necessary to click on the available
directional, type, and interval (15 Min, 1 Day) radio buttons and then click Refresh. This will
display the desired threshold setting.
Step 3 Modify any of the settings listed in Table 20-26 by clicking in the field you want to modify. In some
fields you can choose an option from a drop-down list; in others you can type a value or select or deselect
a check box.
Step 4 Click Apply.
Purpose This task changes threshold settings for STM-N cards.
Tools/Equipment None
Prerequisite Procedures DLP-D60 Log into CTC, page 17-49
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Provisioning or higher
Table 20-26 STM-N Threshold Options
Parameter Description
Port (Display only) Port number.
• 1 (STM-4, STM-16, STM-64)
• 1 to 4 (OC3 IR 4/STM1 SH 1310, OC12 IR/STM4 SH 1310-4)
• 1 to 8 (OC3IR/STM1SH 1310-8)
• 1 to 12: PPM-1 (MRC-12)
EB Errored blocks. Available for Near End and Far End, VC LO or VC4.
ES Errored seconds. Available for Line, Section, or Path; Near End and Far
End.
SES Severely errored seconds. Available for Line, Section, or Path; Near End
and Far End.
BBE Background block errors. Available for Near End and Far End, VC LO or
VC4.
UAS Unavailable seconds. Available for Line or Path; Near End and Far End.
PPJC-PDET Positive Pointer Justification Count, STS Path Detected. Available for
Line; Near End and Far End.
To Next Page
Loading...
