Cisco ONS 15454 SDH - DLP- D314 Assign a Name to a Port

20-7
Cisco ONS 15454 SDH Procedure Guide, R7.0
78-17194-01
Chapter 20 DLPs D300 to D399
DLP- D314 Assign a Name to a Port
Step 7 From the Slot drop-down list, choose the STM-N card to map the low-order VC3, VC11, or VC12 circuit
for optical transport or to map the VC4 circuit to an STM.
Step 8 Click Next.
Step 9 Choose the destination VC4, TUG3, TUG2, and VC12 from the drop-down lists that appear.
Step 10 Check Use Secondary Destination and repeat Steps 1 through 9.
Step 11 Return to your originating procedure (NTP).
DLP-D314 Assign a Name to a Port
Step 1 In node view, double-click the card that has the port you want to provision.
Step 2 Click the Provisioning tab.
Step 3 Click the Port Name column for the port number you are assigning a name to and enter the desired port
name.
The port name can be up to 32 alphanumeric/special characters and is blank by default.
Step 4 Click Apply.
Step 5 Return to your originating procedure (NTP).
DLP-D315 Log Out a User on a Single Node
Step 1 In node view, click the Provisioning > Security > Active Logins tabs.
Step 2 Choose the user that you want to log out and click Logout.
Purpose This task assigns a name to a port on any ONS 15454 SDH card.
Tools/Equipment None
Prerequisite Procedures DLP-D60 Log into CTC, page 17-49
NTP-D24 Verify Card Installation, page 4-2
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Provisioning or higher
Purpose This task logs out a user from a single node.
Tools/Equipment None
Prerequisite Procedures DLP-D60 Log into CTC, page 17-49
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Superuser