21-42
Cisco ONS 15454 SDH Procedure Guide, R7.0
78-17194-01
Chapter 21 DLPs D400 to D499
DLP- D465 Create FC_MR-4 RMON Alarm Thresholds
gfpStatsCSFRaised Number of Rx client management frames with Client Signal Fail
indication.
mediaIndStatsTxFramesTooLong Number of packets transmitted that are greater than 1548 bytes.
mediaIndStatsRxFramesTruncated Total number of frames received that are less than 5 bytes.
Table 21-4 FC_MR-4 Threshold Variables for Fibre Channel/FICON Enhanced Mode
(MIBs)
Variable Definition
iflnOctets Total number of octets received on the interface, including framing
octets.
ifInDiscards The number of inbound packets that were chosen to be discarded
even though no errors had been detected to prevent their being
deliverable to a higher-layer protocol.
iflnErrors Number of inbound packets discarded because they contain errors.
ifOutOctets Total number of transmitted octets, including framing packets.
ifOutDiscards The number of outbound packets that were chosen to be discarded
even though no errors had been detected to prevent their being
transmitted.
fcIngressRxDistanceExtBuffers The maximum number of GFP buffers that are available at the GFP
receiver.
fcEgressTxDistanceExtBuffers The number of GFP buffers that the GFP transmitter is allowed to
transmit. Remote GFP receiver tells the GFP transmitter how many
buffers it has available.
fcStatsLinkRecoveries The number of times a link reset was initiated due to a GFP out of
frame condition. This is only valid when link recovery is enabled and
is not valid when distance extension is enabled.
fcStatsRxCredits The maximum number of Fibre Channel credits that the Fibre
Channel/fiber connectivity (FICON) link partner will allow the
FCMR Fibre Channel/FICON transmitter to transmit (that is, the
maximum number of frames the link partner can receive).
fcStatsTxCredits The number of Fibre Channel credits that the FCMR Fibre
Channel/ficon transmitter is left with. This is the number of frames
that the Fibre Channel/FICON transmitter has available to send.
Note The Tx credits increment whenever a credit is received from
the link partner, and decrement when a frame is sent.
fcStatsZeroTxCredits A count that increments when the Fibre Channel/FICON Tx credits
go from a nonzero value to zero.
fibreStatsInvalidOrderedSets Received ordered sets that are not recognized as part of the defined
Fibre Channel control words.
fibreStatsEncodingDispErrors Received control words that cannot be decoded due to invalid
disparity.
Table 21-3 FC_MR-4 Threshold Variables for Fibre Channel/FICON Line Rate Mode
(MIBs) (continued)
Variable Definition