20-44
Cisco ONS 15454 SDH Procedure Guide, R7.0
78-17194-01
Chapter 20 DLPs D300 to D399
DLP- D340 Change Line and Threshold Settings for the E3-12 Cards
Step 4 Modify any of the settings found under these subtabs by clicking in the field you want to modify. In some
fields you can choose an option from a drop-down list; in others you can type a value or select or deselect
a check box.
Step 5 Click Apply.
Step 6 Repeat Steps 3 through 5 for each subtab that has parameters you want to provision.
For definitions of the line settings, see Table 20-14. For definitions of the line threshold settings, see
Table 20-15. For definitions of the electrical path threshold settings, see Table 20-16. For definitions of
the SDH threshold settings, see Table 20-17.
Table 20-14 describes the values on the Provisioning > Line tab for the E3-12 cards.
Table 20-14 Line Options for E3-12 Cards
Parameter Description Options
Port (Display only) Port number. 1 to 12
Port Name Port name. User-defined, up to 32 alphanumeric/special
characters. Blank by default.
See the “DLP-D314 Assign a Name to a
Port” task on page 20-7.
SF BER Sets the signal fail bit error rate.
• 1E-3
• 1E-4
• 1E-5
SD BER Sets the signal degrade bit error rate.
• 1E-5
• 1E-6
• 1E-7
• 1E-8
• 1E-9
Admin State Sets the port service state unless network
conditions prevent the change. For more
information about administrative states,
refer to the “Administrative and Service
States” appendix of the
Cisco ONS 15454 SDH Reference
Manual.
• Unlocked—Puts the port in service. The
port service state changes to
Unlocked-enabled.
• Unlocked,automaticInService—Puts the
port in automatic in-service. The port
service state changes to
Unlocked-disabled,automaticInService.
• Locked,disabled—Removes the port
from service and disables it. The port
service state changes to
Locked-enabled,disabled.
• Locked,maintenance—Removes the
port from service for maintenance. The
port service state changes to
Locked-enabled,maintenance.
To Next Page
Loading...
