17-56
Cisco ONS 15454 SDH Procedure Guide, R7.0
78-17194-01
Chapter 17 DLPs D1 to D99
DLP- D65 Create a Static Route
DLP-D65 Create a Static Route
Step 1 In node view, click the Provisioning > Network tabs.
Step 2 Click the Static Routing tab. Click Create.
Step 3 In the Create Static Route dialog box, enter the following:
• Destination—Enter the IP address of the computer running CTC. To limit access to one computer,
enter the full IP address and a subnet mask of 255.255.255.255. To allow access to all computers on
the 192.168.1.0 subnet, enter 192.168.1.0 and a subnet mask of 255.255.255.0. You can enter a
destination of 0.0.0.0 to allow access to all CTC computers that connect to the router.
• Mask—Enter a subnet mask. If the destination is a host route (that is, one CTC computer), enter a
32-bit subnet mask (255.255.255.255). If the destination is a subnet, adjust the subnet mask
accordingly, for example, 255.255.255.0. If the destination is 0.0.0.0, CTC automatically enters a
subnet mask of 0.0.0.0 to provide access to all CTC computers. You cannot change this value.
• Next Hop—Enter the IP address of the router port or the node IP address if the CTC computer is
connected to the node directly.
• Cost—Enter the number of hops between the ONS 15454 SDH and the computer.
Step 4 Click OK. Verify that the static route appears in the Static Route window.
Note Static route networking examples are provided in the “Management Network Connectivity”
chapter in the Cisco ONS 15454 SDH Reference Manual.
Step 5 Return to your originating procedure (NTP).
Purpose This task creates a static route to establish CTC connectivity to a computer
on another network.
Tools/Equipment None
Prerequisite Procedures DLP-D60 Log into CTC, page 17-49
Required/As Needed Required if either of the following conditions are is true:
• CTC computers on one subnet need to connect to ONS 15454 SDH
nodes that are connected by a router to ONS 15454 SDH nodes
residing on another subnet. OSPF is not enabled and the External
Network Element gateway setting is not checked.
• You need to enable multiple CTC sessions among ONS 15454 SDH
nodes residing on the same subnet and the External Network Element
gateway setting is not enabled.
Onsite/Remote Onsite or remote
Security Level Provisioning or higher
To Next Page
Loading...
