18-63
Cisco ONS 15454 SDH Procedure Guide, R7.0
78-17194-01
Chapter 18 DLPs D100 to D199
DLP- D175 Remove a TARP Manual Adjacency Table Entry
Step 5 Provision the other tunnel endpoint using the documentation.
Step 6 Return to your originating procedure (NTP).
DLP-D175 Remove a TARP Manual Adjacency Table Entry
Caution If TARP manual adjacency is the only means of communication to a group of nodes, loss of visibility
will occur when the adjacency table entry is removed.
Step 1 In node view, click the Provisioning > OSI > TARP > MAT tabs.
Step 2 Click the MAT entry that you want to delete.
Step 3 Click Remove.
Step 4 In the Delete TDC Entry dialog box, click OK.
Step 5 Return to your originating procedure (NTP).
DLP-D176 Convert E1-N-14 Cards From 1:1 to 1:N Protection
Note This procedure assumes that E1-N-14 cards are installed in Slots 1 through 6 and/or Slots 12 through 17.
The E1-N-14 cards in Slots 3 and 15 are the protect cards. Each protect card protects the other E1-N-14
cards in that half of the shelf. The ONS 15454 SDH must run CTC Software Release 4.0 or later.
Step 1 In node view, click the Maintenance > Protection tabs.
Purpose This task removes an entry from the TARP manual adjacency table.
Tools/Equipment None
Prerequisite Procedures DLP-D60 Log into CTC, page 17-49
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Provisioning or higher
Purpose This task converts E1-N-14 cards in a 1:1 protection scheme to 1:N
protection. A 1:N protection group can protect a maximum of five working
cards.
Tools/Equipment None
Prerequisite Procedures DLP-D60 Log into CTC, page 17-49
Required/As Needed As needed
Onsite/Remote Onsite
Security Level Provisioning or higher
To Next Page
Loading...
