Cisco ONS 15454 SDH - Before You Begin

CHAPTER
10-1
Cisco ONS 15454 SDH Procedure Guide, R7.0
78-17194-01
10
Change Card Settings
This chapter explains how to change line and threshold settings on Cisco ONS 15454 SDH cards.
Before You Begin
Before performing any of the following procedures, investigate all alarms and clear any trouble
conditions. Refer to the Cisco ONS 15454 SDH Troubleshooting Guide as necessary.
Caution Changing card settings can be service affecting. You should make all changes during a scheduled
maintenance window.
This section lists the chapter procedures (NTPs). Turn to a procedure for applicable tasks (DLPs).
1. NTP-D88 Modify Line Settings and PM Parameter Thresholds for Electrical Cards, page 10-2—As
needed, complete this procedure to change line and threshold settings for all electrical cards
(E1-N-14, E1-42, E3-12, DS3i-N-12, and STM1E-12).
2. NTP-D89 Modify Line Settings and PM Parameter Thresholds for Optical Cards, page 10-2—As
needed, complete this procedure to change line and threshold settings for all optical (STM-N) cards.
3. NTP-D118 Modify Alarm Interface Controller–International Settings, page 10-3—As needed,
complete this procedure to change external alarms and controls and/or orderwire settings.
4. NTP-D91 Upgrade E1-N-14 and DS3 i-N-12 Protect Cards from 1:1 Protection to 1:N Protection,
page 10-4—As needed, complete this procedure to change the protection type on E-1 or DS-3 cards.
5. NTP-D311 Modify Port Settings and PM Parameter Thresholds for SAN Cards, page 10-5—As
needed, complete this procedure to change the FC_MR-4 card port and threshold settings.
6. NTP-D330 Change Card or PPM Service State, page 10-5—As needed, complete this procedure to
change the service state on a card or pluggable port module (PPM).
7. NTP-D331 Manage Pluggable Port Modules, page 10-6—As needed, complete this procedure to
provision a multirate PPM, assign the optical line rate, change the optical line rate, and delete PPMs.