11-7
Cisco ONS 15454 SDH Procedure Guide, R7.0
78-17194-01
Chapter 11 Change Node Settings
NTP- D205 Modify Users and Change Security
NTP-D205 Modify Users and Change Security
Step 1 Complete the “DLP-D60 Log into CTC” task on page 17-49. If you are already logged in, continue with
Step 2.
Step 2 Complete the “NTP-D108 Back Up the Database” procedure on page 15-5.
Step 3 Perform any of the following tasks as needed:
• DLP-D271 Change Node Security Policy on a Single Node, page 19-74
• DLP-D272 Change Node Security Policy on Multiple Nodes, page 19-76
• DLP-D437 Change Node Access and PM Clearing Privilege, page 21-25
• DLP-D193 Grant Superuser Privileges to a Provisioning User, page 18-81
• DLP-D158 Change User Password and Security Level on a Single Node, page 18-49
• DLP-D160 Change User Password and Security Level on Multiple Nodes, page 18-50
• DLP-D159 Delete a User on a Single Node, page 18-50
• DLP-D161 Delete a User on Multiple Nodes, page 18-51
Step 4 Complete the “NTP-D108 Back Up the Database” procedure on page 15-5.
Stop. You have completed this procedure.
NTP-D87 Change SNMP Settings
Step 1 Complete the “DLP-D60 Log into CTC” task on page 17-49. If you are already logged in, continue with
Step 2.
Step 2 Complete the “NTP-D108 Back Up the Database” procedure on page 15-5.
Purpose This procedure modifies user and security properties for the ONS 15454
SDH.
Tools/Equipment None
Prerequisite Procedures NTP-D30 Create Users and Assign Security, page 4-4
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Provisioning or higher
Purpose This procedure modifies SNMP settings for the ONS 15454 SDH.
Tools/Equipment None
Prerequisite Procedures NTP-D34 Set Up SNMP, page 4-12
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Superuser only
To Next Page
Loading...
