17-74
Cisco ONS 15454 SDH Procedure Guide, R7.0
78-17194-01
Chapter 17 DLPs D1 to D99
DLP- D82 View Alarms
• Destination Address—Type the IP address of the destination node (32 bit length) or destination
subnet (any other length).
• Length—Choose the length of the destination subnet mask.
Step 4 Click OK.
Step 5 Return to your originating procedure (NTP).
DLP-D82 View Alarms
Step 1 In card, node, or network view, click the Alarms tab to view the alarms for that card, node, or network
(Figure 17-16).
Figure 17-16 CTC Node View
Table 17-3 lists the columns in the Alarms window and their descriptions.
Purpose Use this to view current alarms on a card, node, or network.
Tools/Equipment None
Prerequisite Procedures DLP-D60 Log into CTC, page 17-49
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Provisioning
To Next Page
Loading...
