18-21
Cisco ONS 15454 SDH Procedure Guide, R7.0
78-17194-01
Chapter 18 DLPs D100 to D199
DLP- D122 Enable Intermediate Path Performance Monitoring
Step 7 Click the Performance tab to view performance monitoring (PM) parameters. Refer to the “Performance
Monitoring” chapter in the Cisco ONS 15454 SDH Reference Manual for more PM information, details,
and definitions.
Note The fields for positive pointer justification count (PPJC) and negative pointer justification count
(NPJC) PM parameters appear white and blank unless pointer justification count performance
monitoring is enabled.
Step 8 Return to your originating procedure (NTP).
DLP-D122 Enable Intermediate Path Performance Monitoring
Note The monitored IPPM parameters are P-EB, P-BBE, P-ES, P-SES, and P-UAS. For more information
about IPPM parameters, refer to the “Performance Monitoring” chapter in the Cisco ONS 15454 SDH
Reference Manual.
Step 1 In node view, double-click the STM-N card you want to monitor. The card view appears.
See Table 18-3 on page 18-19 for a list of STM-N LTE cards.
Step 2 Click the Provisioning > VC4 tabs (Figure 18-8).
Purpose This task enables intermediate path performance monitoring (IPPM),
which allows you to monitor large amounts of VC4 traffic through
intermediate nodes.
Tools/Equipment None
Prerequisite Procedures DLP-D60 Log into CTC, page 17-49
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Provisioning or higher
To Next Page
Loading...
