21-12
Cisco ONS 15454 SDH Procedure Guide, R7.0
78-17194-01
Chapter 21 DLPs D400 to D499
DLP- D428 Modify Alarm, Condition, and History Filtering Parameters
Note A previously created alarm profile cannot be deleted unless it has been stored on the node. If the
profile is visible on the Alarm Profiles tab but is not listed in the Select Node/Profile
Combinations to Delete dialog box, continue with Step 8.
Step 4 Click the node names in the Node Names list to highlight the profile location.
Tip If you hold the Shift key down, you can select consecutive node names. If you hold the Ctrl key
down, you can select any combination of nodes.
Step 5 Click the profile name(s) you want to delete in the Profile Names list.
Step 6 Click OK.
Step 7 Click Ye s in the Delete Alarm Profile dialog box.
Note If you delete a profile from a node, it still appears in the network view Provisioning >
Alarm Profiles window unless you remove it using the following step.
Step 8 To remove the alarm profile from the window, right-click the column of the profile you deleted and
choose Remove from the shortcut menu.
Note If a node and profile combination is selected but does not exist, a warning appears: “One or more
of the profile(s) selected do not exist on one or more of the node(s) selected.” For example, this
warning appears if Node A has only Profile 1 stored and the user tries to delete both Profile 1
and Profile 2 from Node A. However, the operation still removes Profile 1 from Node A.
Note The Default and Inherited special profiles cannot be deleted and do not appear in the
Select Node/Profile Combination for Delete window.
Step 9 Return to your originating procedure (NTP).
DLP-D428 Modify Alarm, Condition, and History Filtering Parameters
Step 1 At node, network, or card view, click the Alarms, Conditions, or History tab.
Purpose This task changes alarm and condition reporting in all network nodes.
Tools/Equipment None
Prerequisite Procedures DLP-D225 Enable Alarm Filtering, page 19-24
DLP-D60 Log into CTC, page 17-49
Required/As Needed As needed
Onsite/Remote
Onsite or remote
Security Level
Retrieve or higher
To Next Page
Loading...
