4-7
Cisco ONS 15454 SDH Procedure Guide, R7.0
78-17194-01
Chapter 4 Turn Up a Node
NTP- D169 Set Up CTC Network Access
Step 7 Click Apply.
Stop. You have completed this procedure.
NTP-D169 Set Up CTC Network Access
Step 1 Complete the “DLP-D60 Log into CTC” task on page 17-49. If you are already logged in, continue with
Step 2.
Step 2 Complete the “DLP-D249 Provision IP Settings” task on page 19-52 to provision the ONS 15454 SDH
IP address, subnet mask, default router, DHCP, IIOP listener port, and SOCKS proxy server settings.
Tip If you cannot log into the node, you might be able to change its IP address, default router, and
network mask by using the LCD on the ONS 15454 SDH front panel. See the “DLP-D64 Set the
IP Address, Default Router, and Network Mask Using the LCD” task on page 17-53 for
instructions. However, you cannot use the LCD to provision any other network settings.
Step 3 If you want to turn on the ONS 15454 secure mode, which allows two IP addresses to be provisioned for
the node if TCC2/TCC2P cards are installed, complete the “DLP-D84 Enable Node Security Mode” task
on page 17-77.
Step 4 If static routes are needed, complete the “DLP-D65 Create a Static Route” task on page 17-56. Refer to
the “CTC Network Connectivity” chapter in the Cisco ONS 15454 SDH Reference Manual for further
information about static routes.
Step 5 If the ONS 15454 SDH is connected to a LAN or WAN that uses OSPF and you want to share routing
information between the LAN or WAN and the ONS network, complete the “DLP-D250 Set Up or
Change Open Shortest Path First Protocol” task on page 19-56.
Step 6 If the ONS 15454 SDH is connected to a LAN or WAN that uses RIP, complete the “DLP-D251 Set Up
or Change Routing Information Protocol” task on page 19-58.
Stop. You have completed this procedure.
Purpose This procedure provisions network access for a node, including its subnet
mask, default router, Dynamic Host Configuration Protocol (DHCP)
server, IIOP (Internet Inter-Orb Protocol) listener port, SOCKS proxy
server settings, static routes, Open Shortest Path First (OSPF) protocol,
and Routing Information Protocol (RIP).
Tools/Equipment None
Prerequisite Procedures NTP-D24 Verify Card Installation, page 4-2
Required/As Needed Required
Onsite/Remote Onsite or remote
Security Level Superuser
To Next Page
Loading...
