18-60
Cisco ONS 15454 SDH Procedure Guide, R7.0
78-17194-01
Chapter 18 DLPs D100 to D199
DLP- D172 Provision Additional Manual Area Addresses
DLP-D172 Provision Additional Manual Area Addresses
Step 1 Click the Provisioning > OSI > Routers > Setup tabs.
Step 2 Chose the router where you want provision an additional manual area address and click Edit. The OSI
Router Editor dialog box appears.
Step 3 In the OSI Router Editor dialog box:
a. Check Enable Router to enable the router and make its primary area address available for editing.
b. Click the manual area address, then click Add.
c. In the Add Manual Area Address dialog box, enter the primary area address in the Area Address
field. If you prefer, click Use Mask and enter the address in the Masked NSAP Entry dialog box.
The address (hexadecimal format) can be 2to 24 alphanumeric characters (0–9, a–f) in length.
d. Click OK successively to close the following dialog boxes: Masked NSAP Entry (if used), Add
Manual Area Address, and OSI Router Editor.
Step 4 Return to your originating procedure (NTP).
DLP-D173 Enable the OSI Subnet on the LAN Interface
Note OSI subnetwork points of attachment are enabled on data communications channels (DCCs) when you
create DCCs. See the “DLP-D363 Provision Regenerator-Section DCC Terminations” task on
page 20-68 and the “DLP-D364 Provision Multiplex-Section DCC Terminations” task on page 20-71.
Purpose This task provisions the OSI manual area addresses. Three additional
manual areas can be created for each virtual router.
Tools/Equipment None
Prerequisite Procedures NTP-D24 Verify Card Installation, page 4-2
DLP-D171 Provision OSI Routers, page 18-59
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Provisioning or higher
Purpose This task enables the OSI subnetwork point of attachment on the LAN
interface.
Tools/Equipment None
Prerequisite Procedures DLP-D60 Log into CTC, page 17-49
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Provisioning or higher
To Next Page
Loading...
