Cisco ONS 15454 SDH - Figure 6-11 One Port Bidirectional Transponder Mode

6-94
Cisco ONS 15454 SDH Procedure Guide, R7.0
78-17194-01
Chapter 6 Create Circuits and Low-Order Tunnels
NTP- D241 Provision G-Series Ports for Transponder Mode
Figure 6-11 One Port Bidirectional Transponder Mode
Step 6 To provision two-port unidirectional transponder mode (Figure 6-12):
Note In this step, “Port A” represents the first port in a pair and “Port B” the second port in the pair.
You can pair any two ports on a G-Series card in two-port unidirectional mode.
a. Click the Port A row (for example, Port 1).
b. Uncheck Auto Negotiation. Ports cannot be provisioned in unidirectional transponder mode when
autonegotiation is enabled.
c. In the TXP Port column, choose Port B (for example, Port 2) from the drop-down list.
d. In the TXP Mode column, choose RX Only from the drop-down list. CTC completes the Port B TXP
Port with Port A and TXP Mode with TX Only.
e. Click the Port B row and uncheck Auto Negotiation.
f. Click Apply.
The ports in CTC card view display arrows and a line between the back of the ports.