Cisco ONS 15454 SDH - DLP- D44 Initiate an Electrical Protection Switch

17-35
Cisco ONS 15454 SDH Procedure Guide, R7.0
78-17194-01
Chapter 17 DLPs D1 to D99
DLP- D44 Initiate an Electrical Protection Switch
Step 5 In the confirmation dialog box, click Yes .
Step 6 Return to your originating procedure (NTP).
DLP-D44 Initiate an Electrical Protection Switch
Note A user-initiated switch overrides the revertive delay, that is, when you clear a switch you clear the timer
and traffic reverts immediately.
Step 1 In node view, click the Maintenance > Protection tabs.
Step 2 In the Protection Groups area, select the protection group you want to switch.
Step 3 In the Selected Group area, select the card you want to switch.
Step 4 Click Switch.
Step 5 In the confirmation dialog box, click Yes .
DLP-D45 Install the Fiber Boot
Note You can install the fiber boots on the fiber-optic cables before or after the fibers are attached to the
optical card.
Note The fiber boot does not support the STM16 SH AS 1310, STM16 LH AS 1550, and STM64 LH 1550
cards. The boots are not necessary for these cards because of the angled SC connectors on the cards.
Purpose This procedure explains how to initiate a switch on an electrical card.
Tools/Equipment None
Prerequisite Procedures DLP-D60 Log into CTC, page 17-49
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Maintenance or higher
Purpose This task installs the fiber boot, which protects the fiber from excessive
bending.
Tools/Equipment Fiber boot
Prerequisite Procedures NTP-D16 Install STM-N Cards and Connectors, page 2-7
Required/As Needed As needed
Onsite/Remote Onsite
Security Level None