21-33
Cisco ONS 15454 SDH Procedure Guide, R7.0
78-17194-01
Chapter 21 DLPs D400 to D499
DLP- D442 Preprovision a Slot
Step 14 Return to your originating procedure (NTP).
DLP-D442 Preprovision a Slot
Step 1 In node view, right-click the empty slot where you will later install a card.
Step 2 From the Add Card shortcut menu, choose the card type that will be installed. Only cards that can be
installed in the slot appear in the Add Card shortcut menu.
Note When you preprovision a slot, the card appears purple in the CTC shelf graphic, rather than
white when a card is installed in the slot. NP (not present) on the card graphic indicates that the
card is not physically installed.
Step 3 Return to your originating procedure (NTP).
DLP-D457 Refresh E-Series and G-Series Ethernet PM Counts
Step 1 In node view, double-click the card where you want to view PM counts. The card view appears.
Step 2 Click the Performance > History tabs.
Step 3 From the Interval drop-down list, choose one of the following:
• 1 min
• 15 min
Purpose This task preprovisions a card slot in CTC before you physically install the
card in the ONS 15454 SDH.
Tools/Equipment None
Prerequisite Procedures Chapter 3, “Connect the PC and Log into the GUI”
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Provisioning or higher
Purpose This task changes the window view to display specified E-Series and
G-Series Ethernet PM counts in time intervals depending on the interval
option selected.
Tools/Equipment None
Prerequisite Procedures DLP-D60 Log into CTC, page 17-49
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Retrieve or higher
To Next Page
Loading...
