21-21
Cisco ONS 15454 SDH Procedure Guide, R7.0
78-17194-01
Chapter 21 DLPs D400 to D499
DLP- D434 Run the CTC Installation Wizard for UNIX
h. Click Next.
i. Click Finish.
Note If you are uninstalling the JRE, click Remove.
Step 12 In the Cisco Transport Controller Installation wizard, click Next. The online user manuals install.
Step 13 Click Finish.
Step 14 Return to your originating procedure (NTP).
DLP-D434 Run the CTC Installation Wizard for UNIX
Note If you will log into nodes running CTC software earlier than R4.6, uninstall JRE 1.4.2 or 4.0 and reinstall
JRE 1.3.1_2. To run Software R7.0, uninstall JRE 1.3.1_2 and reinstall JRE 1.4.2 or 5.0. Software R7.0
supports JRE 1.4.2 or JRE 5.0; JRE 1.4.2 is provided on the software CD.
Note JRE 1.4.2 requires Netscape 7.x or Internet Explorer 6.x
Step 1 Verify that your computer has the following:
• RAM—384 MB recommended, 512 MB optimum
• Hard drive—20 GB hard drive recommended with at least 50 MB of space available
• Operating System—Solaris 8 or 9
Note These requirements are guidelines. CTC performance is faster if your computer has a faster
processor and more RAM.
Purpose This task installs the CTC online user manuals, Acrobat Reader 6.0.1,
JRE 1.4.2, and the CTC JAR files. JRE 1.4.2 is required to run CTC
Software R7.0. Preinstalling the CTC JAR files saves time at initial login.
If the JAR files are not installed, they are downloaded from the
TCC2/TCC2P card the first time you login.
Tools/Equipment Cisco ONS 15454 SDH Release 7.0 software CD
Prerequisite Procedures None
Required/As Needed Required if any of the following are true:
• JRE 1.4.2 or JRE 5.0 is not installed.
• CTC online user manuals are not installed and are needed.
• CTC JAR files are not installed and are needed.
Onsite/Remote Onsite or remote
Security Level None
To Next Page
Loading...
