11-2
Cisco ONS 15454 SDH Procedure Guide, R7.0
78-17194-01
Chapter 11 Change Node Settings
NTP- D81 Change Node Management Information
NTP-D81 Change Node Management Information
Step 1 Complete the “DLP-D60 Log into CTC” task on page 17-49 at the node where you want to change the
settings. If you are already logged in, continue with Step 2.
Step 2 Complete the “NTP-D108 Back Up the Database” procedure on page 15-5.
Step 3 In the node view, click the Provisioning > General tabs.
Step 4 Complete the “DLP-D140 Change the Node Name, Date, Time, and Contact Information” task on
page 18-32.
Step 5 Complete the “DLP-D265 Change the Login Legal Disclaimer” task on page 19-71, as needed.
Step 6 After confirming the changes, complete the “NTP-D108 Back Up the Database” procedure on page 15-5.
Stop. You have completed this procedure.
NTP-D201 Change CTC Network Access
Note Additional ONS 15454 SDH networking information and procedures, including IP addressing examples,
static route scenarios, Open Shortest Path First (OSPF) protocol, and routing information protocol
options are provided in the “Management Network Connectivity” chapter of the Cisco ONS 15454 SDH
Reference Manual.
Step 1 Complete the “DLP-D60 Log into CTC” task on page 17-49. If you are already logged in, continue with
Step 2.
Step 2 Complete the “NTP-D108 Back Up the Database” procedure on page 15-5.
Purpose This procedure changes the node name, date, time, contact information, or
the login legal disclaimer.
Tools/Equipment None
Prerequisite Procedures NTP-D316 Set Up Name, Date, Time, and Contact Information, page 4-4
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Superuser
Purpose This procedure changes essential network information, including IP
settings, static routes, and OSPF options.
Tools/Equipment None
Prerequisite Procedures NTP-D169 Set Up CTC Network Access, page 4-7
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Superuser
To Next Page
Loading...
