4-12
Cisco ONS 15454 SDH Procedure Guide, R7.0
78-17194-01
Chapter 4 Turn Up a Node
NTP- D34 Set Up SNMP
Step 2 Complete one or more of the following tasks depending on the protection groups you want to create:
• DLP-D71 Create a 1:1 Protection Group, page 17-62
• DLP-D72 Create a 1:N Protection Group, page 17-63
• DLP-D73 Create a 1+1 Protection Group, page 17-64
Note If a protect card is not installed, you can complete the “DLP-D442 Preprovision a Slot” task on
page 21-33 and continue with the card protection provisioning.
Note To provision Y-cable protection for TXP and MXP cards, refer to the Cisco ONS 15454 DWDM
Procedure Guide.
Stop. You have completed this procedure.
NTP-D34 Set Up SNMP
Step 1 Complete the “DLP-D60 Log into CTC” task on page 17-49 at the node where you want to set up SNMP.
If you are already logged in, continue with Step 2.
Step 2 In node view, click the Provisioning > SNMP tabs.
Step 3 In the Trap Destinations area, click Create.
Splitter TXPP_MR_2.5G
MXPP_MR_2.5G
Splitter protection is automatically provided with the
TXPP_MR_2.5G and MXPP_MR_2.5G cards. For more
information, refer to the Cisco ONS 15454 DWDM Procedure
Guide.
Unprotected Any Unprotected cards can cause signal loss if a card fails or
incurs a signal error. However, because no card slots are
reserved for protection, unprotected schemes maximize the
service available for use on the ONS 15454 SDH.
Unprotected is the default protection type.
Table 4-1 Card Protection Types (continued)
Type Cards Description and Installation Requirements
Purpose This procedure provisions the SNMP parameters so that you can use
SNMP management software with the ONS 15454 SDH.
Tools/Equipment None
Prerequisite Procedures NTP-D24 Verify Card Installation, page 4-2
Required/As Needed Required if SNMP is used at your installation.
Onsite/Remote Onsite or remote
Security Level Provisioning or higher
To Next Page
Loading...
