6-82
Cisco ONS 15454 SDH Procedure Guide, R7.0
78-17194-01
Chapter 6 Create Circuits and Low-Order Tunnels
NTP- D144 Create an E-Series Single-Card EtherSwitch Manual Cross-Connect
• VLAN names
• ONS 15454 SDH circuit nodes
If the circuit information is not correct, click the Back button and repeat the procedure with the correct
information. If the information is correct, check Route Automatically.
Note You can also click Finish, delete the completed circuit, and start the procedure from the
beginning.
Step 21 Click Finish.
Step 22 Complete the “DLP-D220 Provision E-Series Ethernet Ports” task on page 19-18.
Step 23 Complete the “DLP-D221 Provision E-Series Ethernet Ports for VLAN Membership” task on
page 19-19.
Step 24 Complete the “NTP-D146 Test E-Series Circuits” procedure on page 6-89.
Step 25 To create additional circuits (spokes), repeat Steps 3 through 24.
Stop. You have completed this procedure.
NTP-D144 Create an E-Series Single-Card EtherSwitch Manual
Cross-Connect
Note In this procedure, cross-connect refers to a circuit connection created within the same node between the
Ethernet card and an STM-N card that is connected to third-party equipment. You create cross-connects
at the source and destination nodes so that an Ethernet circuit can be routed from source to destination
across third-party equipment.
Step 1 Complete the “DLP-D60 Log into CTC” task on page 17-49 at an ONS 15454 SDH on the network
where you will create the circuit. If you are already logged in, continue with Step 2.
Step 2 If you want to assign a name to the circuit source and destination ports before you create the circuit,
complete the “DLP-D314 Assign a Name to a Port” task on page 20-7. If you want CTC to assign a name
automatically based on circuit type, node name, and sequence number, continue with Step 3.
Purpose This procedure manually creates a single-card EtherSwitch cross-connect
between E-Series Ethernet cards and STM-N cards connected to non-ONS
equipment.
Tools/Equipment E-Series Ethernet cards (E100T-G or E1000-2-G) must be installed at the
circuit source node.
Prerequisite Procedures NTP-D127 Verify Network Turn-Up, page 6-5
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Provisioning or higher
To Next Page
Loading...
