Cisco ONS 15454 SDH - NTP- D153 Reset a Card Using CTC

15-16
Cisco ONS 15454 SDH Procedure Guide, R7.0
78-17194-01
Chapter 15 Maintain the Node
NTP- D153 Reset a Card Using CTC
NTP-D153 Reset a Card Using CTC
Warning Do not reach into a vacant slot or chassis while you install or remove a module or a fan. Exposed
circuitry could constitute an energy hazard. Statement 206
Step 1 Complete the “DLP-D60 Log into CTC” task on page 17-49 at the node where you are performing the
software reset. If you are already logged in, continue with Step 2.
Step 2 Complete the “DLP-D37 Reset a TCC2/TCC2P Card Using CTC” task on page 17-29 as needed.
Step 3 Complete the “DLP-D38 Reset a Traffic Card in CTC” task on page 17-30 as needed to reset an optical
card, electrical card, FC_MR-4 card, or G-Series, E-Series, CE-1000-4, or ML-Series Ethernet card.
Step 4 Complete the “DLP-D102 Hard-Reset a CE-100T-8 Card Using CTC” task on page 18-2 as needed.
Step 5 Complete the “DLP-D103 Soft-Reset a CE100T-8 Card Using CTC” task on page 18-3 as needed.
Stop. You have completed this procedure.
NTP-D215 View G-Series Ethernet Maintenance Information
Step 1 Complete the “DLP-D60 Log into CTC” task on page 17-49. If you are already logged in, continue with
Step 2.
Purpose This procedure resets TCC2/TCC2P, electrical, optical, Ethernet, and
FC_MR-4 cards.
Tools/Equipment None
Prerequisite Procedures One of the following procedures:
• DLP-D332 Install the TCC2/TCC2P Cards, page 20-22
• NTP-D16 Install STM-N Cards and Connectors, page 2-7
• NTP-D17 Install the Electrical Cards, page 2-10
• NTP-D18 Install Ethernet Cards and Connectors, page 2-11
• NTP-D286 Install the FC_MR-4 Cards, page 2-12
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Superuser
Purpose This procedure enables you to view loopback, bandwidth, and J1 path
trace information on a selected G-Series Ethernet card.
Tools/Equipment None
Prerequisite Procedures NTP-D18 Install Ethernet Cards and Connectors, page 2-11
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Retrieve or higher