18-58
Cisco ONS 15454 SDH Procedure Guide, R7.0
78-17194-01
Chapter 18 DLPs D100 to D199
DLP- D169 Add a TARP Manual Adjacency Table Entry
Step 4 In the Delete TDC Entry dialog box, click Ye s .
Step 5 Return to your originating procedure (NTP).
DLP-D169 Add a TARP Manual Adjacency Table Entry
Step 1 In node view, click the Provisioning > OSI > TARP > MAT tabs.
Step 2 Click Add.
Step 3 In the Add TARP Manual Adjacency Table Entry dialog box, enter the following:
• Level—Sets the TARP Type Code that will be sent:
–
Level 1—Indicates that the adjacency is within the same area as the current node. The entry
generates Type 1 PDUs.
–
Level 2—Indicates that the adjacency is in a different area than the current node. The entry
generates Type 2 PDUs.
• NSAP—Enter the OSI NSAP address in the NSAP field or, if preferred, click Use Mask and enter
the address in the Masked NSAP Entry dialog box.
Step 4 Click OK to close the Masked NSAP Entry dialog box, if used, and then click OK to close the Add Static
Entry dialog box.
Step 5 Return to your originating procedure (NTP).
Purpose This task adds an entry to the TARP manual adjacency table (MAT). Entries
are added to the MAT when the ONS 15454 SDH must communicate across
routers or non-SDH NEs that lack TARP capability.
Tools/Equipment None
Prerequisite Procedures DLP-D60 Log into CTC, page 17-49
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Provisioning or higher
To Next Page
Loading...
