6-89
Cisco ONS 15454 SDH Procedure Guide, R7.0
78-17194-01
Chapter 6 Create Circuits and Low-Order Tunnels
NTP- D146 Test E-Series Circuits
NTP-D146 Test E-Series Circuits
Step 1 Complete the “DLP-D60 Log into CTC” task on page 17-49 at the ONS 15454 SDH source Ethernet
node. If you are already logged in, continue with Step 2.
Step 2 On the shelf graphic, double-click the circuit source card.
Step 3 Click the Provisioning > Port tabs.
Step 4 Verify the following settings:
• Mode—Set to Auto, 10 Half, 10 Full, 100 Half, or 100 Full.
• Enabled—Checked.
• Priority—Set to the priority level indicated by the circuit or site plan. Priority does not apply to
E-Series cards in port-mapped mode.
• Stp State—Checked if Spanning Tree Protocol (STP) is enabled for the circuit. STP does not apply
to E-Series cards in port-mapped mode.
Step 5 Click the VLAN tab. If the E-Series cards is not in port-mapped mode, verify that the source port is on
the same VLAN as the destination port.
Step 6 Repeat Steps 2 through 5 for the destination card.
Step 7 At the destination node, connect an Ethernet test set to the destination port and configure the test set to
send and receive the appropriate Ethernet traffic.
Purpose This procedure tests circuits created on E-Series Ethernet cards that are
provisioned for multicard EtherSwitch, single-card EtherSwitch, or
port-mapped mode.
Tools/Equipment Ethernet test set and appropriate fibers
Prerequisite Procedures This procedure assumes that you completed facility loopback tests to test
the fibers and cables from the source and destination ONS 15454 SDHs to
the fiber distribution panel or the DSX, and one of the following
procedures:
NTP-D191 Create an E-Series EtherSwitch Circuit (Multicard or
Single-Card Mode), page 6-72
NTP-D192 Create a Circuit for an E-Series Card in Port-Mapped Mode,
page 6-75
NTP-D142 Create an E-Series Shared Packet Ring Ethernet Circuit, page
6-77
NTP-D143 Create an E-Series Hub-and-Spoke Ethernet Configuration,
page 6-80
NTP-D144 Create an E-Series Single-Card EtherSwitch Manual
Cross-Connect, page 6-82
NTP-D145 Create an E-Series Multicard EtherSwitch Manual
Cross-Connect, page 6-85
Required/As Needed As needed
Onsite/Remote Onsite
Security Provisioning or higher
To Next Page
Loading...
