20-57
Cisco ONS 15454 SDH Procedure Guide, R7.0
78-17194-01
Chapter 20 DLPs D300 to D399
DLP- D349 View ML-Series POS Ports PM Parameters
Step 4 View the PM parameter names that appear in the Param column. The PM parameter values appear in the
Port # columns. For PM parameter definitions, refer to the “Performance Monitoring” chapter in the
Cisco ONS 15454 SDH Reference Manual.
Note To refresh, reset, or clear PM counts, see the “NTP-D257 Change the PM Display” procedure
on page 8-2.
Step 5 Return to your originating procedure (NTP).
DLP-D349 View ML-Series POS Ports PM Parameters
Note For ML-Series card provisioning, refer to the Ethernet Card Software Feature and Configuration Guide
for the Cisco ONS 15454, Cisco ONS 15454 SDH, and Cisco ONS 15327.
Step 1 In node view, double-click the ML-Series Ethernet card where you want to view PM counts. The card
view appears.
Step 2 Click the Performance > POS Ports tabs (Figure 20-12).
Purpose This task enables you to view packet-over-SDH (POS) port PM counts
at selected time intervals on an ML-Series Ethernet card and port to
detect possible performance problems.
Tools/Equipment None
Prerequisite Procedures DLP-D60 Log into CTC, page 17-49
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Retrieve or higher
To Next Page
Loading...
