10-5
Cisco ONS 15454 SDH Procedure Guide, R7.0
78-17194-01
Chapter 10 Change Card Settings
NTP- D311 Modify Port Settings and PM Parameter Thresholds for SAN Cards
NTP-D311 Modify Port Settings and PM Parameter Thresholds
for SAN Cards
Step 1 Complete the “DLP-D60 Log into CTC” task on page 17-49 at the node where you want to change the
STM-N card settings. If you are already logged in, proceed to Step 2.
Step 2 As needed, complete the “NTP-D108 Back Up the Database” procedure on page 15-5.
Step 3 Perform any of the following tasks as needed:
• DLP-D354 Change General Port Settings for the FC_MR-4 Card, page 20-59
• DLP-D355 Change Distance Extension Port Settings for the FC_MR-4 Card, page 20-61
• DLP-D356 Change Enhanced FC/FICON Port Settings for the FC_MR-4 Card, page 20-63
• DLP-D465 Create FC_MR-4 RMON Alarm Thresholds, page 21-40
• DLP-D466 Delete FC_MR-4 RMON Alarm Thresholds, page 21-44
Step 4 As needed, complete the “NTP-D108 Back Up the Database” procedure on page 15-5.
Stop. You have completed this procedure.
NTP-D330 Change Card or PPM Service State
Note On the STM64-XFP and MRC-12 cards, the PPM is equivalent to an optical port.
Step 1 Complete the “DLP-D60 Log into CTC” task on page 17-49 at the node where you want to change the
card service state.
Step 2 Click the Inventory tab.
Purpose This procedure changes the line settings and PM parameter thresholds for
FC_MR-4 cards.
Tools/Equipment None
Prerequisite Procedures NTP-D286 Install the FC_MR-4 Cards, page 2-12
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Provisioning or higher
Purpose This procedure changes a card or port’s service state, which is an
autonomously generated state that gives the overall condition of the port.
Tools/Equipment None
Prerequisite Procedures Chapter 2, “Install Cards and Fiber-Optic Cable”
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Provisioning or higher
To Next Page
Loading...
