18-9
Cisco ONS 15454 SDH Procedure Guide, R7.0
78-17194-01
Chapter 18 DLPs D100 to D199
DLP- D108 Change Line Settings for STM-N Cards
Step 6 Click OK. The newly created port appears in the Pluggable Port Modules area. The row in the Pluggable
Port Modules area turns light blue and the Actual Equipment Type column lists the preprovisioned PPM
as unknown until the actual SFP/XFP is installed. After the SFP/XFP is installed, the row turns white
and the column lists the equipment name.
Step 7 Verify that the PPM appears in the list in the Pluggable Port Modules area. If it does not, repeat Steps 4
through 6.
Step 8 Repeat the task to create a second PPM.
Step 9 Click OK.
Step 10 When you are ready to install the SFP/XFP, complete the “DLP-D335 Install GBIC or SFP/XFP
Devices” task on page 20-28.
Step 11 Return to your originating procedure (NTP).
DLP-D108 Change Line Settings for STM-N Cards
Note For the default values and domains of user-provisionable card settings, refer to the “Network Element
Defaults” appendix in the Cisco ONS 15454 SDH Reference Manual.
Step 1 In node view, double-click the STM-N card where you want to change the line settings.
Step 2 Click the Provisioning > Line tabs.
Step 3 Modify any of the settings listed in Table 18-1.
Step 4 Click Apply.
Purpose This task changes the line transmission settings for STM-N cards.
Tools/Equipment None
Prerequisite Procedures DLP-D60 Log into CTC, page 17-49
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Provisioning or higher
Table 18-1 STM-N Card Line Settings
Parameter Description Options
Port (Display only) Port number.
• 1 (STM-4, STM-16, STM-64)
• 1 to 4 (OC3 IR 4/STM1 SH 1310, OC12 IR/STM4
SH 1310-4)
• 1 to 8 (OC3IR/STM1SH 1310-8)
• 1 to 12 (MRC-12)
Port Name Assign a name to the specified port. User-defined. Name can be up to
32 alphanumeric/special characters. Blank by default.
See the “DLP-D314 Assign a Name to a Port” task on
page 20-7.
To Next Page
Loading...
