Cisco ONS 15454 SDH - Installing Fmecs on the ONS 15454 SDH

1-9
Cisco ONS 15454 SDH Procedure Guide, R7.0
78-17194-01
Chapter 1 Install the Shelf and FMECs
NTP- D220 Install the Power and Signal FMECs
Step 4 Push the FMEC gently into the connector. The ONS 15454 SDH FMECs plug into electrical connectors
on the back panel of the shelf assembly when the screws are tightened. Figure 1-1 shows FMEC
installation.
Figure 1-1 Installing FMECs on the ONS 15454 SDH
Step 5 Tighten the screws.
Step 6 Continue with the “NTP-D6 Install the Power and Ground” procedure on page 1-10.
Stop. You have completed this procedure.
61338
F
A
N
F
A
IL
C
R
IT
M
A
J
M
IN
Mounting screws
Guide rail