17-65
Cisco ONS 15454 SDH Procedure Guide, R7.0
78-17194-01
Chapter 17 DLPs D1 to D99
DLP- D74 Create a New User on a Single Node
Note When you perform a protection switch, do not change the protection group mode from
nonrevertive to revertive or from revertive to nonrevertive.
• Reversion time—If Revertive is checked, click Reversion Time and select a reversion time from the
drop-down list. The range is 0.5 to 12.0 minutes. The default is 5.0 minutes. Reversion time is the
amount of time that will elapse before the traffic reverts to the working card after conditions causing
the switch are cleared. The reversion timer starts after conditions causing the switch are cleared.
Step 7 Click OK.
Step 8 Return to your originating procedure (NTP).
Note When provisioning a line timing reference for the node, you cannot select the protect port of a 1+1
protection group. If a traffic switch occurs on the working port of the 1+1 protection group, the timing
reference of the node automatically switches to the protect port of the 1+1 protection group.
DLP-D74 Create a New User on a Single Node
Step 1 In node view, click the Provisioning > Security > Users tabs.
Step 2 In the Security window, click Create.
Step 3 In the Create User dialog box, enter the following:
• Name—Type the user name. The name must be a minimum of six and a maximum of
20 alphanumeric (a-z, A-Z, 0-9) characters.
• Password—Type the user password. The password must be a minimum of six and a maximum of
20 alphanumeric (a-z, A-Z, 0-9) and special (+, #, %) characters, where at least two characters are
nonalphabetic and at least one character is a special character. The password must not contain the
user name.
• Confirm Password—Type the password again to confirm it.
• Security Level—Choose a security level for the user: RETRIEVE, MAINTENANCE,
PROVISIONING, or SUPERUSER. Refer to the “Security” chapter in the Cisco ONS 15454 SDH
Reference Manual for information about the capabilities provided with each level.
Purpose This task creates a new user for one ONS 15454 SDH.
Tools/Equipment None
Prerequisite Procedures DLP-D60 Log into CTC, page 17-49
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Superuser
To Next Page
Loading...
