18-3
Cisco ONS 15454 SDH Procedure Guide, R7.0
78-17194-01
Chapter 18 DLPs D100 to D199
DLP- D103 Soft-Reset a CE100T-8 Card Using CTC
DLP-D103 Soft-Reset a CE100T-8 Card Using CTC
Note Soft-resetting the CE100T-8 card is errorless in most cases. If there is a provisioning change during the
soft reset, or if the firmware is replaced during the software upgrade process, the reset is not errorless.
Step 1 In node view, right-click the CE100T-8 card to reveal a shortcut menu.
Step 2 Click Soft-reset Card.
Step 3 Click Ye s in the “Are you sure you want to soft-reset this card?” dialog box.
Step 4 Return to your originating procedure (NTP).
DLP-D104 Install the Fiber Clip on 15454_MRC-12 Cards
Note You can install the fiber clip before or after the fibers are attached to the 15454_MRC-12 card.
Step 1 Determine the correct clip to use. Use the short clip with a standard cabinet door and a long clip with an
extended door.
Step 2 Insert the prong of the fiber clip into the rectangular cutout on the sloped face of the faceplate
(Figure 18-1).
Purpose This procedure soft-resets the CE100T-8 card.
Tools/Equipment None
Prerequisite Procedures DLP-D60 Log into CTC, page 17-49
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Superuser
Purpose This task installs a fiber clip, which allows proper routing of the fiber.
Required for 15454_MRC-12 cards. In CTC, the 15454_MRC-12 card
appears as “MRC-12” only.
Tools/Equipment Short or long fiber clip, as needed
Prerequisite Procedures NTP-D16 Install STM-N Cards and Connectors, page 2-7
Required/As Needed As needed
Onsite/Remote Onsite
Security Level None
To Next Page
Loading...
