9-4
Cisco ONS 15454 SDH Procedure Guide, R7.0
78-17194-01
Chapter 9 Manage Alarms
NTP- D69 View Alarm-Affected Circuits
NTP-D69 View Alarm-Affected Circuits
Step 1 Complete the “DLP-D60 Log into CTC” task on page 17-49. If you are already logged in, continue with
Step 2.
Step 2 In network, node, or card view, click the Alarms tab or Conditions tab and then right-click anywhere
in the row of an active alarm or condition.
Note The node view is the default, but you can also navigate to the Alarms tab in the network view or
card view to perform Step 2.
The Select Affected Circuit option appears in the shortcut menu (Figure 9-1).
Figure 9-1 Select Affected Circuits Option
Step 3
Click Select Affected Circuits.
Purpose Use this procedure to view all circuits, if any, that are affected by an alarm
or condition.
Tools/Equipment None
Prerequisite Procedures NTP-D196 View Alarms, History, Events, and Conditions, page 9-2
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Retrieve or higher
To Next Page
Loading...
