20-43
Cisco ONS 15454 SDH Procedure Guide, R7.0
78-17194-01
Chapter 20 DLPs D300 to D399
DLP- D340 Change Line and Threshold Settings for the E3-12 Cards
Note The threshold value appears after the circuit is created.
Step 7 Return to your originating procedure (NTP).
DLP-D340 Change Line and Threshold Settings for the E3-12 Cards
Note For the default values and domains of user-provisionable card settings, refer to the “Network Element
Defaults” appendix in the Cisco ONS 15454 SDH Reference Manual.
Step 1 In node view, double-click the E3-12 card where you want to change the line or threshold settings.
Step 2 Click the Provisioning tab.
Step 3 Depending on the setting you need to modify, click the Line, Line Thresholds, Elect Path Thresholds,
or SDH Thresholds subtab.
Note See Chapter 9, “Manage Alarms” for information about the Alarm Profiles tab.
Note If you want to modify a threshold setting, it might be necessary to click on the available
directional, type, and interval (15 Min, 1 Day) radio buttons and then click Refresh. This will
display the desired threshold setting.
VC LO Virtual circuit (low-order)
VC4 Virtual circuit 4
15 Min radio button Clicking this radio button and then clicking Refresh will cause the
threshold values on this tab to display for 15-minute intervals.
1 Day radio button Clicking this radio button and then clicking Refresh will cause the
threshold values on this tab to display for 1-day intervals.
Table 20-13 SDH Threshold Options for E1-N-14 and E1-42 Cards (continued)
Parameter Description
Purpose This task changes the line and threshold settings for the E3-12 cards.
Tools/Equipment None
Prerequisite Procedures DLP-D60 Log into CTC, page 17-49
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Provisioning or higher
To Next Page
Loading...
