21-44
Cisco ONS 15454 SDH Procedure Guide, R7.0
78-17194-01
Chapter 21 DLPs D400 to D499
DLP- D466 Delete FC_MR-4 RMON Alarm Thresholds
triggers when the rising threshold is crossed. An event is triggered only the first time a rising threshold
is exceeded (otherwise, a single network problem might cause a rising threshold to be exceeded multiple
times and cause a flood of events).
Step 12 Click OK to complete the procedure.
Step 13 Return to your originating procedure (NTP).
DLP-D466 Delete FC_MR-4 RMON Alarm Thresholds
Step 1 In node view, double-click the FC_MR-4 card where you want to delete the RMON alarm thresholds.
Step 2 In card view, click the Provisioning > Line Thresholds tabs.
Step 3 Click the RMON alarm threshold you want to delete.
Step 4 Click Delete. The Delete Threshold dialog box appears.
Step 5 Click Ye s to delete that threshold.
Step 6 Return to your originating procedure (NTP).
DLP-D468 Create a Two-Fiber MS-SPRing Using the MS-SPRing Wizard
Step 1 From the View menu, choose Go to Network View.
Step 2 Click the Provisioning > MS-SPRing tabs.
Step 3 Click Create MS-SPRing.
Step 4 In the MS-SPRing Creation dialog box, set the MS-SPRing properties:
• Ring Type—Choose two-fiber.
Purpose This task deletes RMON threshold crossing alarms for FC_MR-4 ports.
Tools/Equipment None
Prerequisite Procedures DLP-D465 Create FC_MR-4 RMON Alarm Thresholds, page 21-40
DLP-D60 Log into CTC, page 17-49
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Provisioning or higher
Purpose This task creates a two-fiber MS-SPRing using the MS-SPRing wizard.
Tools/Equipment None
Prerequisite Procedures DLP-D60 Log into CTC, page 17-49
Required/As Needed As needed; required to complete MS-SPRing setup
Onsite/Remote Onsite or remote
Security Level Provisioning or higher
To Next Page
Loading...
