17-79
Cisco ONS 15454 SDH Procedure Guide, R7.0
78-17194-01
Chapter 17 DLPs D1 to D99
DLP- D85 Lock Node Security
DLP-D85 Lock Node Security
Caution This task is irreversible. Do not proceed unless you want the node to permanently have two IP addresses.
Step 1 Click the Provisioning > Security > Data Comm tabs.
Step 2 Click Lock.
Step 3 In the Confirm Lock Secure Mode dialog box, click Yes .
Step 4 Return to your originating procedure (NTP).
DLP-D86 Modify MIC-C/T/P Port IP Settings
Caution Provisioning an IP address that is incompatible with the ONS 15454 SDH network might be service
affecting.
Step 1 Click the Provisioning > Security > Data Comm tabs.
Step 2 Modify the following fields, as necessary:
• IP Address
Purpose This task locks the ONS 15454 SDH security mode. When security mode
is locked, two IP addresses must always be provisioned for the node, one
for the TCC2P LAN (TCP/IP) port, and one for the MIC-C/T/P LAN port.
Tools/Equipment TCC2P cards must be installed.
Prerequisite Procedures DLP-D60 Log into CTC, page 17-49
DLP-D84 Enable Node Security Mode, page 17-77
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Superuser
Purpose This task modifies the ONS 15454 SDH MIC-C/T/P IP address, subnet
mask, and default router. It also modifies settings that control MIC-C/T/P
IP address visibility in CTC and the ONS 15454 SDH LCD. To perform
this task, secure mode must be enabled.
Tools/Equipment TCC2P cards must be installed.
Prerequisite Procedures NTP-D108 Back Up the Database, page 15-5
DLP-D60 Log into CTC, page 17-49
DLP-D84 Enable Node Security Mode, page 17-77
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Superuser
To Next Page
Loading...
