1-2
Cisco ONS 15454 SDH Procedure Guide, R7.0
78-17194-01
Chapter 1 Install the Shelf and FMECs
Required Tools and Equipment
12. NTP-D226 Install and Close the FMEC Cover, page 1-17—Complete this procedure to install the
FMEC cover.
13. NTP-D13 Perform the Shelf Installation Acceptance Test, page 1-18—Complete this procedure to
determine if you have correctly completed all other procedures in the chapter.
Warning
This unit is intended for installation in restricted access areas. A restricted access area is where
access can only be gained by service personnel through the use of a special tool, lock and key, or
other means of security, and is controlled by the authority responsible for the location.
Statement 37
Warning
Ultimate disposal of this product should be handled according to all national laws and regulations.
Statement 1040
Warning
A readily accessible two-poled disconnect device must be incorporated in the fixed wiring.
Statement 91
Note The ONS 15454 SDH is suitable for mounting on concrete or other noncombustible surfaces only.
Note In this chapter, “shelf assembly” refers to the steel enclosure that holds cards and connects power, and
“node” refers to the entire hardware and software system.
Required Tools and Equipment
You need the following tools and equipment to install and test the ONS 15454 SDH.
Cisco-Supplied Equipment
These materials are required for installation and are supplied with the ONS 15454 SDH. The shipped
quantity of each item is in parentheses.
• Double-hole grounding lug for ground connection with a wire receptacle to accommodate the
recommended 13.3 mm² (#6 AWG) multi-strand copper wire (1)
• M4 x 8 mm pan-head Phillips screws (2)
• M6 x 20 mm socket set screws (2)
• M6 x 20 mm pan-head Phillips screws (8)
• Tie wraps 0.125-inch (3.2 mm) W x 6.0-inch (152 mm) L (24)
• ESD wrist strap (disposable) (1)
• Pinned Allen key for front door (1)
• Hex key 3-mm long arm (1)
• Bottom brackets for the fan-tray air filter
To Next Page
Loading...
