20-25
Cisco ONS 15454 SDH Procedure Guide, R7.0
78-17194-01
Chapter 20 DLPs D300 to D399
DLP- D333 Install the XC-VXL-10G, XC-VXL-2.5G, or XC-VXC-10G Cards
DLP-D333 Install the XC-VXL-10G, XC-VXL-2.5G, or XC-VXC-10G Cards
Note When installing cards, allow each card to boot completely before installing the next card.
Caution The XC-VXL-2.5G cross-connect card only works for rates up to STM-16.
Step 1 Open the latches/ejectors of the first XC-VXL-10G, XC-VXL-2.5G, or XC-VXC-10G card that you will
install.
Step 2 Use the latches/ejectors to firmly slide the card along the guide rails until the card plugs into the
receptacle at the back of the slot (Slot 8 or 10).
Step 3 Verify that the card is inserted correctly and close the latches/ejectors on the card.
Note It is possible to close the latches/ejectors when the card is not completely plugged into the back
panel of the shelf assembly. Ensure that you cannot insert the card any further.
Step 4 Verify the LED activity:
• The red LED turns on for 20 to 30 seconds.
• The red LED blinks for 35 to 45 seconds.
• The red LED remains on for 5 to 10 seconds.
• All LEDs blink once and turn on.
• The ACT/STBY LED turns on.
Note If you insert a card into a slot provisioned for a different card, all LEDs turn off.
Note If the red FAIL LED does not turn on, check the power.
Note If the red FAIL LED is on continuously or the LEDs act erratically, the card is not installed
properly. Remove the card and repeat Steps 1 to 4.
Step 5 Verify that the ACT/STBY LED is green for active.
Step 6 Use the latches/ejectors to firmly slide the second cross-connect card along the guide rails until the card
plugs into the receptacle at the back of the slot (Slot 8 or 10).
Purpose This task installs the ONS 15454 SDH cross-connect cards.
Tools/Equipment XC-VXL-10G, XC-VXL-2.5G, or XC-VXC-10G cards
Prerequisite Procedures DLP-D332 Install the TCC2/TCC2P Cards, page 20-22
Required/As Needed Redundant cross-connect cards are required.
Onsite/Remote Onsite
Security Level None
To Next Page
Loading...
